EZSync usb to RS485 Cable with TX/RX LEDs, USB-RS485-WE compatible, EZSync010

Description

Every EZSync cable is built to last for years with high quality industrial grade materials. The cable works with all Windows and Mac OS versions including the latest Windows 10 and Mac OS X 10.12(Sierra). The USB-RS485 cable is a USB to RS485 levels serial UART converter cable incorporating FTDI's FT232R USB to serial UART interface IC device which handles all the USB signaling and protocols. The cable provides a fast, simple way to connect devices with an RS485 interface to USB. This cable has 6 outputs: GND(Black), Data-(Yellow), 5vPower(RED), Terminator1(Brown), Data+(Orange), Terminator 2(Green). In the cable, there is a 120 ohm resistor connected in between Terminator 1 and Terminator 2.
USB-RS485 converter cable provides a USB to RS485 serial interface with customized end connectors
Entire USB to RS485 translation protocol handled by the electronics over-molded in the cable.ESD Protection for RS-485 I/O's ±15kV Human Body Model (HBM) ±15kV EN61000-4-2 Air Gap Discharge ±8kV EN61000-4-2 Contact Discharge
EIA/TIA-485 communication interface with low power requirements. Overmolded FT232R chipset provides single chip USB to asynchronous serial data transfer interface. Works with all Windows and Mac OS versions
Visual indication of Power and Tx/Rx data traffic via LEDs in the transparent USB connector
Cable dimensions: 6 feet or 1.8m length, 5.0mm diameter. Wire gauge: 6 wires, 0.16mm *7 strands each. Please refer to the datasheet attached in "Technical Specification" section of this page for additional information